Deck Update #12
By CosmicConservativeI think I'm going to rename this blog "Deck Building Conservative" since that's all I talk about anymore....
So if you go back and read my first updates on the deck, you'll see that I originally was not intending to replace every board in the deck except the foundation posts themselves. When I first started I was planning to replace the decking and I figured I'd have to replace some of the joists, not all of them. I hadn't planned on replacing any of the deck beams or girders at all. So when I first started putting new joists up, I attached them to the existing beams.
Then I encountered the first of many deck problems that caused me to have to rethink the strategy. That was the famous board splice that the previous deck builder had done. Since I already had hung several joists by the time I found that little gem, I went ahead and replaced the bad board but essentially did the same thing and spliced the new board onto the existing board.
Well, now that I've replaced every other board, I have pretty much convinced myself that I should have replaced that original board too.
The problem is that I have now hung about 15 joists on that section of the deck. But it is bugging me to the point that I have finally decided I need to go back, remove all the joists, remove the original board and then rehang all the joists.
That's probably another day's worth of work, but the alternative is to have an unsightly splicing of old and new boards right in the front of my house, as well as having the very real possibility that the old board could crack or rot out several years before the other boards need to be replaced, and then I would have to take up the entire section of deck to do that. If I replace it now, it's much easier to do.
But it is yet another delay.
Other than this revelation, I have a single railing board left to install before I am "done" with all the railing and could start on the balustars. Or to put it another way, it was beginning to look like I was getting done with this thing....
Sigh.
Comments (0)
No comments on this post.