New 3D printer technology
By CosmicConservativeNew to me anyway...
So pretty much all of the 3D printers I've been posting about and watching for the past few years have been one of two basic techniques, one of which has two basic technologies.
The first technique is the "extrude and build up" technology. This is when you take a long thread or strip of plastic or ABS or some other material and it is pushed through a guide (the "extruder") and then heated at the tip (the "print head") so it melts and deposits a bit of material which then builds up the object.
The second technique is for the printer to be full of a material and the top of the material has some binding agent, or melting process which creates a layer of solid material, which is then pulled below the surface and another layer is bound or melted on top. This is done both with liquids (which are usually bound with ultraviolet or laser light) and with powders (which are usually melted or solidified using a binding agent, like glue).
In general the low cost printers are those that use the extruder build-up process and the higher cost, higher quality printers are the ones that use the dust or liquid.
But there is a new type of printer that I saw in my "Make" magazine, and I find it really intriguing. It uses a UV activated liquid resin and an off-the-shelf projector to create the layers. the layers are built up from below (meaning the image is projected through a layer of glass from underneath).
The reason I find this new printer so intriguing is that it doesn't build the object bit by bit. It actually solidifies an entire layer of resin all at once by focusing an image of the object layer onto the resin. So each layer is a solid sheet of hardened resin, with no weak spots where the material was glued together, nor are there any areas where the material dangles or drips because the print head had to move with some melted plastic or binding agent still dripping off (they call that "stringing"). So it creates exceptionally clean, smooth results. Plus they are as detailed as the projector can focus in the X-Y dimensions, and as detailed as the machinery can elevate the object in the Z dimension. The results of the prototype I saw were simply stunningly detailed and smooth compared to the other printers.
I was totally blown away.
The prototype I saw will end up costing about $2,500 I think. And it has a "build area" of about 4x4x4 inches, which is pretty tiny.
But wow, what awesome results.
Comments (4)